|
TD-6021油封旋转性能试验机
Oil seal circumgyrating performance tester
概述
油封旋转性能试验机适用各种回转式油封进行密封性能的试验和研究工作，油封安装在试验机上，主轴以一定的速度回转，经过一定时间的运行，观察油封是否渗漏，每次可试验2件油封，测试轴可正、反转。本机结构合理，设计新颖，起动性能性好，起动力矩大，调速范围广，转速变化率小，噪声低，操作方便。符合GB/T 14273《旋转轴唇密封圈性能试验方法》等标准要求。
Features and use: It suits for testing oil seal performance of all kinds of turn round type oil seal.Oil seal is putting on the tester and principal axis turns round with a certain speed.Whether the oil seal has leakage after running is important.It can test 2 pieces every time. Test axis can turn positively and negatively.The tester structure is in reason,starting performance is good,and timing range is extensive,noise is low.It suits for GB/T 14273.
技术参数：
1、主轴转速：最高8000r/min(也可按用户要求确定)
2、主轴跳动误差：小于±0.03mm
3、轴心偏置调整量：0mm--5mm
4、可测试油封轴孔范围：Ф80mm--Ф200mm
5、温控范围：常温--120℃
6、控制方式：伺服电机驱动、气动加压，直 线导轨，PLC控制
7、电机功率：2.2kw×2
8、电 源：AC380V三相四线制（必须有零线）
50Hz
9、外型尺寸：1300mm×1000mm×1500mm
10、重 量：420kg
Main
Parameters:
1、Principal axis rev: Max
6000r/min(according to customer''s needs)
2、Principal moving up and down
error: ＜±0.03mm
3、Axle centre deviating adjusting
amount: 0mm--5mm
4、Oil seal axle hole range that
can be tested:Ф80mm--Ф200mm
5、Range of temperature controlled:
normal temperature--120℃
6、Controlled method: shift gears
with frequency
conversion,line guide and PLC.
7、Power of motor: 2.2kw×2
8、Power supply: AC380V 3-phase
4-wire system 50HZ
9、Overall dimension: 1300mm×1000mm×1500mm
10、Weight: 420kg
 |
|
|
|
 |
